If it’s plugged in but the light is still off, your router or modem might not be working properly. If it isn’t, ensure your router or modem is connected to electricity. To determine if a connectivity issue results from malfunctioning internet equipment, find your router or modem and conduct the following checks: Is the problem with your internet equipment? Some of the reasons behind internet outages could be as simple as a loose wire or as complex as a complete service failure caused by a severed supply line resulting from a falling tree branch, for instance. Learning how to troubleshoot internet issues begins with figuring out potential sources of the issues. Troubleshooting internet issues with your Wi-Fiįind out why you have no internet connection Troubleshooting internet issues with your equipment Once the user is connected to the Internet, the page below will show a Next button that can be used to continue with the device setup.In this guide Find out why you have no internet connection The user will not be able to continue without that connection. It requires the user to connect to the Internet. When the device is not connected to the Internet, the end-user will receive a message as shown below. Once the configuration is in place and a reset is performed on the device, there will be an additional check during the device setup. Let’s end this post by looking at the end-user experience. In other words, it’s not applicable during the initial out-of-box experience. Note: This setting must be configured before it’s applicable. On the Device restrictions blade, click OK On the General blade, select Require with Require users to connect to network during device setup and click OK to return to the Device restrictions blade. On the Device restrictions blade, select General to open the General blade. Profile type: Select Device restrictions.Description: (Optional) Provide a description for the device configuration profile.Name: Provide a unique name for the device configuration profile.On the Create profile blade, provide the following information and click Create On the Device configuration – Profiles blade, select Create profile to open the Create profile blade Open the Azure portal and navigate to Microsoft Intune > Device configuration > Profiles to open the Device configuration – Profiles blade That device configuration profile can be assigned to an Azure AD group. The following four steps walk through the steps to get create a new device configuration profile and the specific configuration option. Now let’s continue by looking at the required configuration. The device must be configured once before the setting is applicable.The device must run Windows 10, version 1809 or later.Configurationīefore looking at the configuration, let’s start with a few important requirements and limitations: Having said that, as this setting is configured via the TenantLockdown CSP, I can imagine that, in a Windows Autopilot for existing devices scenario, this can be configured as a Windows default, via PowerShell, by using the WMI Bridge Provider. At this moment it’s simply legally not allowed to require an Internet connection on a device during the initial setup. However, to my understanding this is currently not possible due to legal requirements. Of course it would be great if this configuration option could be a Windows default, or available via the Windows Autopilot configuration. Minor detail, this configuration option must be configured once. That’s often what organizations want to prevent, as it disconnects a device from the organization. IntroductionĬonfiguring a device without Internet connectivity would enable a user to configure the device with a local user and without an enrollment to Microsoft Intune (and Azure AD). Followed by the configuration steps and the end-user experience. In this blog post, I’ll start with a short introduction about why this configuration option would be useful and what the options are with this configuration option. Requiring an Internet connection during device setup can be useful when trying to prevent users from resetting the device (either accidently or on purpose) and configuring it without an Internet connection, as configuring a device without Internet connectivity would enable a user to configure the device with a local user and without enrollment. That configuration option is to require an Internet connection during the device setup. This week I’m going to look at a well hidden configuration option that is recently introduced and can be really useful in specific scenarios.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |